parts list cutterhead body V7

2x insert spirol series 16 m4
3x insert spirol series 16 m3
2x bolt WS 9335 M4x8mm (for mounting head to overhead, may vary)
8x bolt DIN 912 M2x16mm
4x bolt DIN 912 M3x6mm
2x bolt DIN 912 M3x18mm
2x bolt DIN 912 M2x8mm (for heating wire clips)
8x washer M2
8x nyloc nut M2
2x nut M3 (for V spring, nyloc will be very hard to mount)
metal stock 2mm x 10mm
steel wire 1mm (straight stock, stiff)
alu tube 6mm OD 5mm ID
2x alligator clips (small ones) 
2x Fischer Elektronik ICK S R 285X185 heatsink
1x Kerafol Keratherm KL 90 40x40 thermal tape 0,3mm
2x M3 spacers 20mm
1x econ connect BU9LK/V Dsub female connector
2x visaton BF32 drivers
thick running epoxy ( I use Pattex Super Mix Metal 5min)

Multiple Mini Metal Perfume Funnels (you need 2 but you need to cut them down, so a couple of extra's won't hurt).
Size: approx.2cm x 1.8cm x 0.4cm (0.79 x 0.7 x 0.16 inch) (H x D1 x D2)
These you can find on ebay / aliexpress / others...


Only for mono stylus torque tube:

1x setscrew DIN 916 A2 - M3x3mm (crater head) or aluminium if you can find it